Skip to main content

Building

important

Clone with git clone --recurse-submodules: derisk, mcsapi and pm are git submodules under components/ (What this trusts from outside).

The flake reads a few environment variables to decide where an image updates from, so pass --impure when you build an image, installer, QCOW2, release, UKI or VM. With none set, the image updates from the channel's newest GitHub release, as Updating from GitHub Releases describes. LOSOS_PROXY_URL is the base URL of a deployment of proxy/, covered in Binary cache. When it is set, the image updates from that deployment instead, and pings it.

nix build --impure              # the disk image: dd it to a disk and boot
nix build .#installer --impure  # the installer ISO
nix build .#release --impure    # the files CI publishes
nix run .#vm --impure           # boot the image in QEMU with UEFI firmware
nix flake check        # both architectures, losos-security's and
                       # losos-installer's tests, and
                       # (on a builder with KVM) a VM boot test

Nix substitutes the stock nixpkgs closure from cache.nixos.org when it can. It builds the image and the project's own packages locally unless the project's binary cache has them. systemd-repart builds the image inside the build sandbox, with no loop device, no root and no KVM. Only the VM tests need KVM.

important

The build user has to be able to make user namespaces: systemd-repart runs under unshare --map-root-user. Ubuntu 23.10 and later refuse them to unprivileged processes through AppArmor, and the image then fails to build. Lift that with sudo sysctl -w kernel.apparmor_restrict_unprivileged_userns=0, as CI does, or keep it across reboots in a file under /etc/sysctl.d/.

warning

CI builds every other check first and boots the VM tests last. A VM test that fails there is a warning and a line in the run's summary, not a red run, so a boot that breaks under the runner's KVM does not hold back the nightly. Run nix flake check locally to see one fail for real.

just has short names for the same commands. just plugins builds pm's plugin components into plugins/dist/share/pm/plugins, for a pm installed outside the image (pm on LosOS).

Before trusting a change to nixos/, evaluate every target. That runs every module and assertion without building an image:

nix eval --raw .#nixosConfigurations.losos-desktop-x86_64.config.system.build.toplevel.drvPath
nix eval --raw .#nixosConfigurations.losos-desktop-aarch64.config.system.build.toplevel.drvPath
nix eval --raw .#nixosConfigurations.losos-desktop-gsi-aarch64.config.system.build.toplevel.drvPath

nix fmt formats the Nix files, and CI runs nix fmt -- --ci.